已经安装了一个系统(rhel-server-6.4-x86_64-dvd.iso). KVM在哪集.主机和客机分配了自己的IP地址,为此桥接器配置了br0.一切正常.现在我们必须在结合方面建立一座桥梁.
将主机置于以下设置：
[root@server ~]# cat /etc/sysconfig/network-scripts/ifcfg-eth0 DEVICE=eth0 HWADDR=f0:92:1c:0f:76:f8 MASTER=bond0 SLAVE=yes ONBOOT=yes [root@server ~]# cat /etc/sysconfig/network-scripts/ifcfg-eth1 DEVICE=eth1 HWADDR=F0:92:1C:0F:76:FC MASTER=bond0 SLAVE=yes ONBOOT=yes [root@server ~]# cat /etc/sysconfig/network-scripts/ifcfg-bond0 DEVICE=bond0 ONBOOT=yes BRIDGE="br0" [root@server ~]# cat /etc/modprobe.conf alias bond0 bonding options bond0 mode=1 miimon=100 [root@server ~]# cat /etc/sysconfig/network-scripts/ifcfg-br0 DEVICE="br0" NM_CONTROLLED="no" ONBOOT="yes" TYPE="Bridge" BOOTPROTO="static" IPADDR="10.2.26.39" GATEWAY="10.2.26.1" MTU="1500" NETMASK="255.255.255.0" DEFROUTE="yes" IPV4_FAILURE_FATAL="yes" IPV6INIT="no" NAME="System br0"
查看：
[root@server ~]# cat /proc/net/bonding/bond0 Ethernet Channel Bonding Driver: v3.6.0 (September 26,2009) Bonding Mode: fault-tolerance (active-backup) Primary Slave: None Currently Active Slave: eth1 MII Status: up MII Polling Interval (ms): 100 Up Delay (ms): 0 Down Delay (ms): 0 Slave Interface: eth0 MII Status: down Speed: Unknown Duplex: Unknown Link Failure Count: 0 Permanent HW addr: f0:92:1c:0f:76:f8 Slave queue ID: 0 Slave Interface: eth1 MII Status: up Speed: 10000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: f0:92:1c:0f:76:fc Slave queue ID: 0
eth0失败了.虽然我期待看到如下内容：
[root@server ~]# cat /proc/net/bonding/bond0 Ethernet Channel Bonding Driver: v3.6.0 (September 26,2009) Bonding Mode: fault-tolerance (active-backup) Primary Slave: None Currently Active Slave: eth0 MII Status: up MII Polling Interval (ms): 100 Up Delay (ms): 0 Down Delay (ms): 0 Slave Interface: eth0 MII Status: up Speed: 10000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: f0:92:1c:0f:d5:e8 Slave queue ID: 0 Slave Interface: eth1 MII Status: up Speed: 10000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: f0:92:1c:0f:d5:ec Slave queue ID: 0
问题本身在一个主题中,如何在RHEL 6.4 Server中配置桥接绑定？
